Beginner’s Guide to Crown Molding and Pot Light Installation Crown molding and pot lighting installation can be done DIY using the proper tools and equipment, and having the right skills, but it can also be intimidating because walls are not always flat and nailing can be difficult. How can you achieve a beautiful crown molding? For a more dramatic crown, we will teach you how to install a crown molding that has the combination of standard crown molding with two-pieces of base trim. It is a good idea measuring the length of the wall for the crown molding so you can buy pieces that are long enough to span each wall, and to prevent scarfing pieces together. Choose the same tone if you want to use a light-colored stain, and crown molding can be installed using a hammer, handsaw, and miter box. You can choose to install your crown molding using a brad nailer and miter saw for better results and faster work. If you want a rich and larger look od your crown molding, you can combine it with other types of trim like those with contrasting woods to achieve a two-tone effect. Built-up crown offers a lot of benefits such as eliminating nailing frustrations. In order for you to know where to drive the nails, you can use a chalk to put markings and lines, although professional carpenters put lines and marks right on the ceilings and wall, and just hide them with paint later on. For an easier work, you can use an easy-release masking tape with at least 2 inches wide to stick on walls and ceilings. Tape will not stick properly if the walls or ceilings are just newly painted, so you need to wait for a couple of weeks before using tape. Now, you can install the trim over the masking tape, and leave it in place to protect your ceiling and walls when you paint or apply a finishing coat. When it comes to the actual trim placement, add the piece to the right next to the first piece in place, and work around the room in that direction, so in that way, you will make most of your 45-degree cuts using a miter saw. It makes your job a lot easier to hold, cutting marks easier to see. Remember that you need to miter your ceiling rails both exterior and interior corners, and test the pieces to determine the exact angle. When coping wall rails, it is like coping the crown but you need to stand the trim against the saw’s fence when you’re making the 45-degree miter, and install the outside corners the last to avoid coping both ends. It can be daunting and confusing having a DIY crown molding and pot installation project, so do not hesitate to contact a professional carpenter to help you. Check our moulding contractors review on our website now.Practical and Helpful Tips: Lights
Practical and Helpful Tips: LightsIt appears that your web host has disabled all functions for handling remote pages and as a result the BackLinks software will not function on your web page. Please contact your web host for more information.